USA: Fern Park 32730 - Florida
1 - 407 - 9126035
BRITCO PULLEY LAGGING

ARROWHEAD CERAMIC CONVEYOR PULLEY LAGGING

Corrects Belt Slippage And Premature Wear Arrowhead ceramic pulley lagging provides the solution when conventional rubber lagging fails to correct belt slippage and wears prematurely.
Our unique Arrowhead ceramic is designed for the highest drive factors unlike the conventional square tiles.

MSHA approved for mine use – meets all requirements for flame resistant solid products taken into mines. Acceptance Marking No. MSHA IC -174/2

• Increase Productivity – by delivering increased traction between the conveyor belt and pulley, allows for lower belt tension than with rubber lagging.
• Improved Conveyor Belt Tracking – due to the Arrowhead patterns self-cleaning ability, which reduces material build up and thereby eliminates the major source of conveyor belt misalignment.
• Bonding Strength – that is superior to others, due to 3mm of our neoprene compound vulcanized into bottom-side of the lagging.
• Superior Wear – ability in abrasive or highly wet or dry applications as seen in below ground and above ground mining.
• Easy Installation – can be done in place, on plant site, at your local distributor or at the pulley manufacturer. Each strip is 10” (250mm) wide x pulley face (see chart).
• 3 Year Warranty
• Newly Improved Ceramic Tile
• High grade aluminum oxide ceramic
• Tile fully enclosed by rubber
• Rounded corners allow for better adhesion between the rubber and the tile


Ir Arriba
ADDRESS
USA: Fern Park 32730 - Florida
CALL CENTER
1 - 407 - 9126035
Whatsapp: +1845-518-7074
E-MAIL
Si tienes alguna consulta escribenos: sales@britcobrs.com
FOLLOWS

© Copyright 2018, Britco - All rights reserved.    |      Diseño Web: Publinet